Installation Manual
H3C S5100-SI/EI Series Ethernet Switches
Chapter 3 Installing the Switch
3-27
(4)
(2)
(5)
(1)
(3)
(4)
(2)
(5)
(1)
(3)
(4)
(2)
(5)
(1)
(3)
(4)
(2)
(5)
(1)
(3)
(4)
(2)
(5)
(1)
(3)
(1): Switch
(2): Filler panels for optional module slots
(3): Small cover plate (removed) in the middle on the filler panel
(4): Push-in direction
(5): XENPAK optical module
Figure 3-37
Installing an XENPAK optical module
Step 4: Tighten the fastening screws on the XENPAK optical module with a screwdriver
to fix the XENPAK optical module on the filler panel.
Note:
z
Keep the removed small cover plate properly for future use.
z
When tightening the fastening screws at both sides of the optional module with a
screwdriver or an electric screwdriver, make sure that the torque is not bigger than
0.4N•m.
z
Hot swapping of XENPAK optical modules is supported.
III. Removal
Step 1: Put on an ESD-preventive wrist strap and verify the ESD-preventive wrist strap
properly grounded.
Step 2: Loosen the fastening screws at both sides of the XENPAK optical module using
a flathead screwdriver.
Step 3: Pull the XENPAK optical module towards you, until it completely comes out of
the switch chassis.
