Installation Manual
H3C S5100-SI/EI Series Ethernet Switches
Chapter 3 Installing the Switch
3-14
I. Introduction to magnetic accessories
A set of magnetic mounting accessories consists of one permanent magnets and one
M3*6 countersunk head screws, as shown in Figure 3-18. Four sets of magnetic
mounting accessories are needed for each S5100 switch.
(1)
(2)
(1) Permanent magnet
(2) M3*6 countersunk head screw
Figure 3-18
Magnets and countersunk head screws
II. Installation procedure
Follow these steps to complete magnet mounting:
1)
As shown in Figure 3-19, use a Phillips screwdriver to pass the countersunk head
screw through the round hole at the central of the permanent magnet, fasten it to a
blind nut in the dent of the switch bottom, and ensure that the permanent magnet
and the switch are fastened reliably.
Note:
z
Remove the cushion, if any, from the dent before installation.
z
To ensure the firmness of installation, be sure to use four permanent magnets to
secure each S5100 switch.
2)
Attach the magnet-mounted device to the specified location. Take care not to get
your fingers stuck between because the magnetism is very huge.
