operation
file: n:\article\cos14310m5-v1_08hpc-en\20150130_cos14310m5-v1.08hpc-en_instructions_for_use_h-p-cosmos_treadmill.doc
© 2015 h/p/cosmos sports & medical gmbh author: fh [email protected] created 30.01.2015 printed 30.01.2015 page: 48 of 216
5.10.2
Manual mode
The following table shows the operating steps for running the treadmill via firmware or software h/p/cosmos para
control.
Operation of profile mode
Initiation: Running belt is not moving. One of the modes LED
is flashing: (manual, profile, cardio, test)
Step no.
Activity
Keys
Response / Display
[01]
Select manual mode
a
or
d
Alteration of the mode (manual, profile, cardio, test)
until
manual is flashing
[02]
Start manual mode
c
A
: standard (in case of deactivation in the optional functions):
manual, km/h, m and % are illuminated
met,
energy and power are illuminated alternately
Running belt accelerates up to the pre-selected starting speed
(standard: 0.5 km/h, can be changed in the optional settings),
start of measuring
%
indicates present heart rate: P. 40 ... P. 220. The display indicates every
single heart beat with a flashing dot behind the P.
B:
In case of activation in the optional functions:
%
indicates: 65 flashing (for 65 kg body weight),
weight is illuminated
Enter the actual body weight with
a
or
d
, then
c
for an accurate calculation
of the POWER and ENERGY consumption.
Further steps see A
[03]
Alteration of speed
a
or
d
press and hold
Speed is being increased / reduced (0-max)
If speed is being reduced to 0, PAUS is displayed
=
.
Current values will
be sustained.
[04]
Alteration of
acceleration/
deceleration level
a
or
d
press and hold
Example: to select acceleration level “3”, press the corresponding key 3 times
and then hold. (Standard value = 4, maximum 7 levels, may be limited by
optional settings)
[05]
Pause mode
a
PAUS is displayed.
=
.
Running belt stops. All displays stop. Current
values will be sustained. After restart with
d
or
c
all displayed values will be
"added".
[06]
Alteration of elevation
f
or
e
press and hold
Elevation is being increased / reduced (0 ... max.)
[07]
Switch to the next or
previous mode
c
+
d
or
c
+
a
Switch to the next or previous mode.
This is a perfect way to change the mode without stopping the belt.
[08]
Stop running belt
b
Running belt stops.
(Deceleration time can be adjusted in the optional functions)
Displayed values and selected mode remain for 2 minutes and will then be
deleted (reset) automatically (or after second time pressing the stop button).
