21
3.5 Connectors
Here in the motherboard contains IDE , floppy , power input, front panel, back
panel and additional connectors.
3.5.1 Primary IDE Connector (J14, 39-pin block)
This connector supports two primary channel IDE
devices via a ribbon cable. When two IDE devices
are installed using the primary IDE connector, make
sure that the second IDE device is set to slave mode
as indicated in the device’s manual.
3.5.2
Secondary IDE Connector (J18, 39-pin block)
This connector supports two secondary channel IDE
devices as well as the 120MB Floppy drives via a
ribbon cable. When two IDE devices are installed
using the secondary IDE connector, make sure that
the second IDE device is adjusted to slave mode as
instructed in the device’s manual.
3. INSTALLATION
1
2
40
39
WARNING:
When you connect a ribbon cable
to these ports, you must orient the cable
connector so that the PIN 1 edge of the cable is
at the PIN 1 edge of the onboard connector.
1
2
40
39
WARNING:
When you connect a ribbon cable
to these ports, you must orient the cable
connector so that the PIN 1 edge of the cable is
at the PIN 1 edge of the onboard connector.
Summary of Contents for KR632
Page 5: ...5 CONTENTS...
Page 9: ...9 Photo Of The Motherboard 2 FEATURES...
Page 30: ...30 3 INSTALLATION...