Guilin Woodpecker Medical Instrument O-Star CURING LIGHT, Instruction Manual, Page: 5 / 23

4
Output: 5.0V 1A
The adapter must be complies with IEC 60601-1 and IEC 60601-1-2.
3.7 Light source:
3.7.1 10W high power
3.7.2 Wave length: 385nm~515nm
3.7.3 Class: class 2
3.7.4 AEL: 3.9×10
-3
J
3.7.5 Check method: When operate machine properly, LED luminous means
LED is in good condition.
3.7.6 The wavelength of our curing light machine can match with dental resin
material which are commonly used on clinical, such as 3M and Dentsply.
3.7.7 440 nm to 490 nm (blue light ) wavelength range of radiation: not less
than 250 mw/cm
2
.
3.7.8 Work condition:
Environment temperature: +5°C to +40°C
Relative humidity: 30%~75%
Atmosphere pressure: 70kPa to106kPa
3.8 Safety classification
3.8.1 Protection type against electrical shock: Class II
3.8.2 Protection degree against electrical shock: Type B
3.8.3 Protection against harmful ingress of water or particular matter: ordinary
equipment (IPX0),can’t be waterproof.
3.8.4operation mode: short time run equipment.
3.8.5 Safety in the presence of flammable anesthetic mixture with air, oxygen
or nitrous oxide: not suitable under this condition.
4. Installation
4.1 Aim the mounting holes which on the upper of main unit, and make the
long side of the top of main unit inserted to it (must screw the top of main unit to
the end, don’t inclined inserted). The top of main unit can rotate 360 degrees.
4.2 Take out the disposable sleeve and put it on the main unit.
WARNING: The disposable sleeves are single patient use only. Discard
used disposable sleeves in standard waste after each patient.
4.3 Clip the notch of the light hood into the head of the top of main unit, and
then clamp the light hood down on the main unit.
4.4 When the battery needs to be charged, connect the plug of the adapter
into the AC100V-240V power supply. Then connect the output plug of the
adapter to the DC 5.0V input plug of the charging base, then put the main unit
into the charging base. Please pull out the adapter plug after charging.
CAUTION: When charging, it is necessary to insert the screen front of
the main unit and the screen front of the charging base in the same direction,