25
Press the Setting button “P” again, the
“Auto Standby Scr” can be changed, press
Adjusting button “+”/“-” to adjust the time ,
and then press "Main" button to confirm.
If no buttons are pressed, auto return to
standby display of the motor handpiece can be
set from 3to 30 seconds in 1 second
increments.
Press the Setting button “P” again, the
"Dominant Hand" can be changed, press
Adjusting button “+”/“-” to adjust, then press
the “Main” button to confirm. The right hand
or the left hand can be set.
Press the Setting button “P” again, the
“Calibration” can be changed, press the
Adjusting button “+”/“-” to select “ON”, then
press the “Main" button to calibrate.
Before calibrating, make sure the original
contra-angle is installed before inserting any
file.
The torque set will not be correct if calibration
is done without the original contra-angle or
any load is applied on the contra-angle chuck
and may result in file separation. After
replacement of the contra-angle, the contra-
angle should be calibrated before use.
Press the Setting button “P” again, the
"Beeper Volume" can be changed, press the
Adjusting button “+”/“-” to adjust, then press
the "main" button to confirm. The “Beeper
Volume “can be set from 0-3.
Vol.0: Mute.
Press the Setting button “P” again, the
"Restore Defaults" can be changed, press
adjusting button “+”/“-” to select “ON”, then
press the main button to restore defaults.
Summary of Contents for Ai-Motor MotoPex
