6.10
Align the pulleys
Preliminary requirements
•
Wrench size 17 (2x)
•
Alignment ruler
Procedure
1. Remove the cover of the belt. Refer to section
2. Hold the alignment ruler (B) against
the flat surface of both pulleys (A).
3. Do a check to see if there are gaps
between the ruler and the pulley
surfaces.
4. If there are gaps, use the nuts (C) to
adjust the engine.
5. Repeat the steps 2, 3 and 4 until
there are no gaps between the ruler
and the pulley surfaces.
6. Put back the cover.
B
A
A
C
Preventive maintenance
D09-GS13S50-
1
2
31
