5.3
Start the machine
Preliminary requirements
1.
The panic bar is in the upper position.
2.
The input and the output are installed.
3.
The deflector is set to the required position.
Warning:
Only start the machine when the input and shredderbox are empty.
Procedure
1. Start the machine. Refer to the OEM documentation of the specific engine of your
machine.
5.4
Use the machine
Note:
For an overview of the product specifications, refer to section
1. If necessary, remove sand, dirt and
rocks from the material.
2. Cut side branches off the main
branches.
3. Put the material in the input (A).
The machine automatically pulls the
material into the rotor.
4. Put side branches and material with a
large diameter in the input separately.
5. After you put branches with leaves in
the input, always put a thicker branch
without leaves in the input to prevent
a blockage.
5.5
Stop the machine
1. Put the last material in the input. Refer to section
2. Let the machine operate until the shredderbox and the output are empty.
3. Set the throttle lever in low speed position.
4. Set the ON/OFF switch to the OFF position.
A
Instructions for use
22
D09-GS13S50-
1
2
