GST-M200 Intelligent Fire Alarm Control Panel
Installation and Operation Manual
Page 19
In input mode, the cursor indicates the position. To input numbers, press the
number keys directly. If
“*” is to be used, press the “*” key. If more than one data
section exists, the cursor goes to the next section after the present section is finished.
Press TAB to go to the next, or
△
＝
,
＝
▽
to the previous. Within a section, press
△
＝
or
＝
▽
to change the input position.
For text input, pressing * to change among input modes for capital letter (T) and
lower case (t), number input (1) and text (w).
Input of capitalized and lower case characters: Taking ABC 2 as an example.
Pressing this key once,
“A” is input. Pressing twice for “B” and three times for “C”.
Pressing four times, it
’s “A” again. If a letter is input, and no key is pressed in 2
seconds, the cursor will move to the next position. Symbols can be selected by
pressing
“+” among the following options: “blank”; “-“; “(“; “)”; “
！
”; ”,”; “,”; “.”;
“+”, “-”; “&”; “=”; “*”; “@”; “
＃
”; “$”; “
％
”; “[“; “]”.
Number input: Press the numbers on the keys.
User-defined text input: When the screen indicates
“w”, press any number key to
enter phrase selection screen. Selecting the number of the phrase and pressing
ENTER
can insert this phrase to the cursor position.
Modifying input message: Pressing
△
＝
and
＝
▽
to move the cursor for modification.
3.2 Description of Programming Screens
If
MODE
is pressed, six options will be available on the screen as shown in Fig. 3-1: Read
Status, Programming, Autoprogram, Disable/Enable, Walk Test, and Configure Item. In
which
Read Status
and
Programming
have multiple levels of submenu that can be
accessed by pressing number keys, or exited at any time by pressing
ESC
repeatedly.
Fig. 3-1
3.3 Programming and Passwords
There are two user-programming levels:
Master password is used for programming panel specific data relating to device types,
*MODE*
1.
Read Status
2.
Programming
3.
Autoprogram
4.
Disable/Enable
5.
Walk Test
6.
Configure Item
Summary of Contents for GST-M200
Page 1: ......