GSI Group PNEG-1421, Assembly & Operation Manual

Page: 11 / 52

11
PNEG-1421 Direct Gear Drive Bin Sweep Auger
DECALS
• KEEP OUT OF BIN DURING UNLOADING
OPERATIONS.
• WHEN BIN WELLS ARE IN OPEN POSITION
CONVEYING MECHANISM IS NOT COVERED.
FAILURE TO HEED WILL RESULT IN
SERIOUS INJURY OR DEATH!
DC-1266
Check components shown below to insure that the safety decals are in place and in good condition. If a decal cannot
be easily read for any reason or has been painted over, replace it immediately. Contact your dealer or the manufacturer
to order a replacement decal free of charge.
SAFETY DECALS
Pa rt # De scription S ize
DC-1834
Im porta nt
- Power Sweep Position 7-3/8" x 2-3/4"
DC-1266
Da nge r
- B in W ell 7-1/2" x 2-1/2"
DC-1384 Da nge r - K eep Out of Bin 6-1/4" x 1-1/4"
DC-1395
Da nge r
- Rotating Flight 4-1/4" x 6-1/4"
DECAL PART LIST
DC-1834
DC-1266
DC-1384
DC-1834
AUGER
TUBE
6" & 8" Control Rod Location
- Control for Intermediate
Well Gates (Pull To Open)
I - Control for Center Well
Gate (Pull to Open)
OUTER ROD
NNER ROD
10" Control Rod Location
- Control for Intermediate
Well Gates (Pull To Open)
I - Control for Center Well
Gate (Pull to Open)
OUTER ROD
NNER ROD
POWER SWEEP CLUTCH CONTROL -
(Pull To Engage Power Sweep)
IMPORTANT: BEFORE FILLING BIN CLOSE CENTER WELL
AND INTERMEDIATE WELL GATES. POSITION SWEEP
AUGER OVER INTERMEDIATE WELLS.
INSTRUCTIONS:
1. BE SURE POWER SWEEP CLUTCH CONTROL IS
DISENGAGED AND TIGHTEN SET SCREW.
2. START UNLOADING AUGER. OPEN CENTER WELL GATE.
3. WHEN GRAIN STOPS FLOWING FROM CENTER WELL
GATE, OPEN INTERMEDIATE WELLS.
4. WHEN GRAIN STOPS FLOWING FROM INTERMEDIATE
WELLS, STOP AUGER. TO ENGAGE POWER SWEEP,
ROTATE UNLOADING AUGER SLOWLY UNTIL CLUTCH
ENGAGES AND TIGHTEN SET SCREW. START AUGER.
KEEP OUT OF BIN WHILE SWEEP IS IN OPERATION
RAPIDLY TRAVELING SWEEP AUGER
FAILURE TO HEED WILL RESULT IN
SERIOUS INJURY OR DEATH
DC-1384