23
Special Functions
Controlling recording from
external units
If the recorder is connected at socket EXT. 2 with an
external unit which is equipped with a timer with
control signal, the external unit can be used to con-
trol recording at the recorder.
❒
Preparation
Insert a cassette with sufficient playing time. Pay
attention to erase protection.
❒
Preparing the EURO-AV socket for the
external unit
Call up the info table using the
h
button.
Use the
DC
buttons to select the » A 2 Record
Prepared « line and call it up using the
G
button.
– The » A 2 RECORD PREPARED « table appears.
Use the
F
or
E
button to activate the record
prepared function.
Store the setting using the
G
button.
– The recorder is in record stand-by mode. The
time of recording is controlled by the external
unit.
– Display at recorder: »
RECORD PREP
«.
w
!
If this function has been selected, TIMER recording
and operation with a decoder are not possible.
w
!
To cancel the function, repeat the setting starting at
step
. Switch the record stand-by setting (see
step )
to “OFF”.
3
1
4
3
A2
RECORD PREPARED
OFF
ON
– – – – – – – – – – – – – – – – – – –
i u
OK i
2
1
1
Continuous playback mode
❒
Preparation for continuous playback
mode
Insert a recorded cassette.
Start playback using the
T
button on the remote
control or the
S
button on the recorder.
Press the
H
button on the remote control or the
i
button on the recorder at the position where
playback is to end.
Press the
¢
CODE
button, the numbered buttons
8 5 0 1
and the
G
button in sequence.
– Display at recorder: »
CONTINUOUS
«.
❒
Starting continuous playback
Start the function using the
T
button on the
remote control or the
S
button on the recorder.
– The tape is rewound to the beginning, where play-
back starts.
The tape runs to the marked position. Then the
tape is rewound to the beginning and playback
starts again.
❒
Terminating the continuous mode
function
Press the
N
button on the remote control or the
P
button on the recorder.
1
1
4
3
2
1
