Grizzly G0887, Owner'S Manual, Page: 60 / 108

-58-
Model G0887 (Mfd. Since 01/19)
Inspecting Drive Belt
Inspect drive belt regularly for tension and wear.
Refer to
Figure 93 for proper belt tension. Belt
deflection should be approximately
1
⁄
4
" under
moderate pressure. The replacement belt can
be found in the back of this manual in the parts
breakdown.
Pulley
Deflection
Pulley
Figure 93.
Checking belt tension.
1
⁄
4
"
To replace the drive belt or adjust the tension,
refer to
Replacing/Tensioning Drive Belt on
Page 74.
4. Remove coolant pump access panel (see
Figure 92).
5. Thoroughly clean reservoir and pump filter
with hot, soapy water, then rinse with clean
water. You may need to remove coolant
pump bracket screws to access pump filter.
6. Clean and wrap drain plug threads with
Teflon tape, then install drain plug.
7. Mix 10 gallons of coolant according to cutting
fluid manufacturer's specifications, then refill
tank with coolant.
8. Replace chip collection drawer.
Figure 92. Coolant pump access panel removed.
Coolant Pump
Access Panel
x 4
Figure 91. Drain plug location.
Drain Plug
3. Remove drain plug, empty tank, and dispose
of coolant per federal, state, and manufac-
turer requirements (see
Figure 91).