Grizzly G0827, Owner'S Manual

Page: 52 / 92

-50-
Model G0827 (Mfd. Since 11/17)
Ram Ways
Oil Type ......Model T23962 or ISO 68 Equivalent
Oil Amount ............................................Thin Coat
Lubrication Frequency .........40 Hrs. of Operation
Move the ram as necessary to gain access
to the entire length of the ram dovetail ways
(see
Figure 87), use mineral spirits and shop
rags to clean the ways, then apply a thin coat of
lubricant.
Figure 87. Ram dovetail ways.
Ram Dovetail Ways
Z-Axis Bevel Gears
Grease Type ......... NLGI#2 Grease or Equivalent
Oil Amount ............................................Thin Coat
Lubrication Frequency .........80 Hrs. of Operation
Use mineral spirits, shop rags, and a brush to
clean the old grease from the teeth of the bevel
gears shown in
Figure 88.
When dry, use a clean brush to apply a thin coat
of grease to the teeth, then move the table up and
down to evenly distribute the grease.
Figure 88. Location of Z-axis bevel gears.
X- & Y-Axis Power Feed Gears
Grease Type .........T23964 or NLGI#2 Equivalent
Amount .................................................Thin Coat
Add Frequency ....................40 Hrs. of Operation
To lubricate power feed gears:
1. DISCONNECT MACHINE FROM POWER!
2. Remove acorn nut and handwheel from
power unit end of the X-axis leadscrew
(see
Figure 89).
3. Unthread and remove knurled retaining ring
and graduated dial ring from end of leadscrew
(see
Figure 89).
Figure 89. X-Axis handwheel components to
remove to lubricate power feed gears.
Acorn Nut
Knurled
Retaining Ring
Graduated
Dial
Handwheel