Grizzly G0827, Owner'S Manual

Page: 27 / 92

Model G0827 (Mfd. Since 11/17)
-25-
Mill Test Run
1. Clear all setup tools away from machine.
2. Set vertical spindle to 140 RPM (see Page 36
for details on how to change speeds).
9. Listen for abnormal noises and watch for
anything unexpected from mill. It should run
smoothly and without excessive vibration or
rubbing noises.
— Strange or unusual noises or actions
must be investigated immediately. Turn
machine
OFF and disconnect it from the
power source before investigating or cor-
recting potential problems.
3. Push E-STOP button (see Figure 22) to
avoid unexpected start up when machine is
connected to power.
Figure 22. Location of E-STOP button.
E-STOP Button
4. Connect mill to power supply specified in
POWER SUPPLY on Page 14.
5. Turn master power switch ON (see Figure 23).
6. Twist E-STOP button clockwise until it pops
out—this resets it and allows mill to operate.
Figure 24. Location of vertical spindle
FORWARD button and POWER button.
FORWARD
Button
(Vertical
Spindle)
7. Press POWER button (see Figure 24) on
control panel to enable power to machine—
power button should illuminate.
8. Press FORWARD button (see Figure 24) for
(vertical spindle).
POWER
Button
Figure 23. Location of master power switch.
Master
Power
Switch