Grizzly G0820, Owner'S Manual, Page: 80 / 104

-78-
Model G0820 (Mfd. Since 12/16)
7. Loosen angle scale knob bolt (see Figure
159 on Page 77) to allow fence to pivot.
8. Loosen hex nut on the 0° stop bolt shown
in
Figure 160 on the previous page, rotate
0° stop bolt to square crosscut fence, then
retighten hex nut.
9. Move crosscut fence stop block against 0°
stop bolt, then retighten angle scale knob bolt
to secure fence in place.
10. Repeat Steps 5–6 until both measurements
are within
1
⁄
16
".
Riving Knife
Mounting Block
The riving knife and splitter/riving knife must be
aligned with the blade when installed. If either one
is not aligned with the blade, then the workpiece
will be forced sideways during the cut, which will
increase the risk of kickback.
The riving knife and splitter/riving knife mount to
a block that can be repositioned to correctly align
the riving knife or splitter/riving knife to the blade.
The mounting block adjusts by turning the set
screws in each corner of the block.
Figure 163
shows the set screws associated with controlling
the mounting block position. Have patience when
adjusting the mounting block, because it requires
trial-and-error to perform with accuracy.
Figure 163. Riving knife and splitter/riving knife
mounting block adjustment controls.
Side
Control
Side
Control
Mounting Block
Face View
Top Control
Bottom Control
All adjustment and alignment positions for the
riving knife and splitter/riving knife are covered
on
Page 43 in the subsection Riving Knife
Installation & Removal, and on Page 41 in the
subsection
Splitter/Riving Knife Installation
& Removal. The mounting block should not be
adjusted unless you have been unable to mount
the riving knife or splitter/riving knife as instructed
by these procedures.
Tools Needed Qty
Straightedge ...................................................... 1
Open-End Wrench 17mm .................................. 1
Hex Wrench 2.5mm ........................................... 1