Grizzly G0820, Owner'S Manual, Page: 32 / 104

-30-
Model G0820 (Mfd. Since 12/16)
36. Thread M12-1.75 x 55 adjustable lock handle
with a 12mm flat washer through hole in short
side of crosscut table and into a M12-1.75
T-nut plate, as shown in
Figure 41.
Figure 41. Crosscut lock handle installed on
crosscut table.
x 1
37. With assistance from other people, place
crosscut table on swing arm pivot pin and slide
T-slot alignment plates and T-nut plate into
sliding table T-slot, as shown in
Figure 42.
Figure 42. Attaching crosscut table to machine
frame.
Swing Arm
Pivot Pin
Crosscut Table
T-Nut Plate
38. Remove tap screws and end cap from cross-
cut fence (see Figure 43).
40. Attach 0° stop block to T-nut with (1) M8-1.25
x 35 cap screw and (1) 8mm lock washer
(see
Figure 45).
Note: Make sure threaded hole in stop block
is positioned right of cap screw and aligned
with hole to right of stop bolt.
Figure 43. End cap removed from crosscut
fence.
End Cap
x 2
39. Slide M8-1.25 T-nut into T-slot in bottom of
crosscut fence (see Figure 44) and position
in front of stop bolt.
Figure 44. T-nut installed in bottom T-slot of
crosscut fence for stop block.
T-Nut
Figure 45. 90° stop block installed.
Stop
Bolt
Threaded Hole 0° Stop Block
Lock
Handle
T-Nut
Plate
T-Slot
Alignment
Plates
T-Slot
T-Slot
Stop Bolt
Hole