Model G0820 (Mfd. Since 12/16)
-5-
Front Controls
J. Crosscut Table Lock Lever. Secures cross-
cut table when locked; allows crosscut table
to be repositioned along sliding table when
unlocked.
K. Tilt Scale. Displays the tilt angle of blades in
degrees.
L. Blade Tilt Handwheel. Adjusts the tilt angle
of both blades. The lock knob in the center
secures the handwheel to prevent blade from
moving during operation.
M. Sliding Table Lock Lever. Allows sliding
table to be locked in stationary position when
turned clockwise; allows sliding table to move
horizontally when turned counterclockwise.
N. Magnetic ON/OFF Switch: Green start but-
ton turns motor
ON when pressed. Red
Emergency Stop button turns motor
OFF
when pressed; for safety purposes, this button
will remain depressed and prevent restarting
until reset. Reset by rotating clockwise until it
pops out.
Figure 3. Front controls.
Rear Controls
O. Main Blade Elevation Handwheel. Raises
and lowers the main blade. The lock knob in
the center secures the handwheel to prevent
blade from moving during operation.
P. Rear Emergency Stop Button. Turns motor
OFF. Twist clockwise until it pops out to reset.
Figure 4. Rear controls.
K
J
L
M
N
P
O
Scoring Blade Controls
Q. Scoring Blade Elevation Bolt. Raises
and lowers the scoring blade to match kerf
thickness of main blade using the T-handle
wrench.
R. Scoring Blade Alignment Bolt. Adjusts the
alignment of scoring blade to the main blade
using the T-handle wrench.
Figure 5. Riving knife controls.
Q
R
Summary of Contents for G0820
Page 104: ......