Grizzly G0820, Owner'S Manual, Page: 26 / 104

-24-
Model G0820 (Mfd. Since 12/16)
Assembly
The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to
Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
To assemble sliding table saw:
1. Remove shipping brace shown in Figure 18
from end of sliding table.
3. Pull sliding table forward a few inches and
attach end plate with handle, as shown in
Figure 20, using (2) M6-1 x 20 button head
cap screws, (4) 6mm flat washers, (2) 6mm
lock washers, and (2) M6-1 hex nuts.
Figure 19. End cap attached to sliding table.
x 2
End Cap
2. Attach end cap with (2) pre-installed M4 x 8
tap screws (see Figure 19).
Figure 18. Shipping brace location.
Figure 20. End plate with handle installed onto
sliding table.
4. Attach end cover to sliding table with (3) pre-
installed M5-.8 x 10 button head cap screws
(see
Figure 21).
5. Slide M12-1.75 T-nut on push handle assem-
bly into T-slot at front end of sliding table, as
shown in
Figure 21, then tighten handle. It
may be necessary to loosen T-nut first.
Note: Make sure pre-installed 12mm flat
washer and 12mm copper washer are posi-
tioned in front of T-slot, as shown in
Figure 21.
x 2
End Plate
w/Handle
Shipping Brace
Figure 21. End cover and push handle installed.
x 3
End Cover
T-Slot
Push Handle