Grizzly G0764, Owner'S Manual, Page: 59 / 124

Model G0764 (Mfd. Since 02/14)
-57-
Rip Cutting with Rip Fence
1. Move crosscut table and fence to front of slid-
ing table, and lock them in place with cross-
cut table lock lever (see
Figure 105).
Vertical
Horizontal
Figure 108. Rip fence positions.
4. Place fence in vertical position (see Figure
108) for thicker workpieces, or in horizontal
position for thinner workpieces and for angled
cuts where blade is tilted over the fence.
3. Loosen slide lock lever shown in Figure 107.
Figure 107. Location of slide lock lever.
Slide Lock
Lever
Figure 105. Location of crosscut table lock lever.
Figure 106. Location of sliding table lock lever.
Sliding Table
Lock Lever
2. Lock sliding table in place with table lock
lever (see Figure 106).
5. Position leading edge of rip fence so it
extends across extension wing, as shown in
Figure 109, then retighten lock lever.
Figure 109. Proper position of rip fence.
Rip Fence
Rip Fence Lock
Lever
6. Lift rip fence lock lever (see Figure 109) and
adjust fence to approximate width of cut.
7. Tighten micro-adjust lock knob (see Figure
109), then turn micro-adjust knob to fine tune
width of cut.
8. Push rip fence lock lever down to secure
fence assembly in position.
9. Load workpiece onto table saw. The setup
should look similar to Figure 103 on Page
56.
10. Take all necessary safety precautions, then
perform cutting operation.
Micro-Adjust
Lock Knob
Micro-Adjust
Knob
Crosscut
Table Lock
Lever