Grizzly G0764, Owner'S Manual, Page: 37 / 124

Model G0764 (Mfd. Since 02/14)
-35-
53. From underneath right end of crosscut fence,
insert M8-1.25 T-nut into crosscut fence
T-slot, then thread M8-1.25 x 25 knob bolt
with nylon tip through T-nut and into place-
ment hole (see
Figure 51). This secures
crosscut extension fence in place.
Figure 51. Knob bolt and placement hole
(viewed from underneath crosscut fence).
Placement Hole
Knob
Bolt
54. Thread (2) M20-2.5 x 130 studs through front
side of cabinet wall and into welded hex nuts.
(Refer to
Figure 52 for location).
55. Slide lower guard arm over studs, then finger
tighten (2) M20-2.5 hex nuts with (2) 20mm
flat washer onto studs (see
Figure 52). Make
sure connecting flange faces up.
56. Use level and adjustment bolt and hex nut
shown in Figure 52 to level lower guard arm,
then fully tighten stud hex nuts.
57. Loosely attach middle guard arm to lower
guard arm with (4) M8-1.25 x 25 cap screws,
(4) 8mm lock washers, and (4) 8mm flat
washers (see
Figure 53).
58. Thread (4) M8-1.25 x 12 set screws into
threaded holes next to cap screws installed
in
Step 57.
59. Use a level and set screws to level middle
guard arm.
Figure 53. Middle section of guard arm attached
to lower section.
x 4
x 4
Middle
Guard Arm
60. Slide blade guard arm brace shown in Figure
54 around middle guard arm, and secure it to
extension table with (1) M10-1.5 x 25 button
head cap screw, (1) 10mm flat washer, and
(1) M10-1.5 hex nut.
Figure 54. Arm brace attached to middle guard
arm and extension table.
x 4
Brace
Figure 52. Lower guard arm attached.
Connecting Flange
Adjustment Bolt
& Hex Nut
Studs,
Flat Washer,
& Hex Nuts