Grizzly G0764, Owner'S Manual, Page: 35 / 124

Model G0764 (Mfd. Since 02/14)
-33-
42. With assistance from other people, place
crosscut table on swing arm pivot pin and
slide T-nut plate into sliding table T-slot, as
shown in
Figure 45.
43. Slide (2) M8-1.25 T-nuts into crosscut table
brace T-slots, and align them with center
holes in crosscut table (see
Figure 46).
Figure 46. Example of table brace attached to
crosscut table.
Crosscut Table Brace
44. Secure table brace by threading (2) M8-1.25
x 50 knob bolts with (2) 8mm flat washers into
brace T-nuts (see
Figure 46).
45. Turn crosscut fence onto its side.
46. On crosscut fence end nearest blade:
a. Insert (1) M8-1.25 T-nut into T-slot, then
loosely thread M8-1.25 pivot bolt with
8mm fiber flat washer into T-nut (see
Figure 47).
b. Position crosscut fence so edge cap (see
Figure 47) is close to but not touching
main blade.
c. Align the pivot bolt with pivot hole (see
Figure 47), then fully tighten pivot bolt.
Note: Long knob and fender washer will
help secure crosscut fence in later step.
Figure 45. Attaching crosscut table to machine
frame.
Swing Arm
Pivot Pin
T-Slot
Figure 47. Crosscut fence hardware near to
blade.
Long Knob
& Fender Washer
T-Nut, Pivot Bolt,
& Fiber Flat Washer
Pivot
Hole
Crosscut Table
T-Nut Plate
End Cap