-56-
Model G0764 (Mfd. Since 02/14)
The Model G0764 has the capability of rip cutting
large panels (see
Figure 102). The sliding table
removes the burden of sliding a large and heavy
panel over a stationary table surface.
Rip Cutting
Determine which cutting operation will be best
suited for the workpiece to be ripped.
•
To use the sliding table, read the instructions
titled “Rip Cutting with Sliding Table.”
•
To use the machine as a traditional table saw,
skip ahead to “Rip Cutting with Rip Fence.”
Rip Cutting with Sliding Table
1. Position crosscut fence on crosscut table,
and rotate it until fence touches 0° stop bolt
(
Figure 104).
Figure 102. Rip cut with sliding table and
crosscut fence.
Crosscut
Fence
Edge Shoe
Workpiece
This saw also has the capability of rip cutting
smaller boards, using the machine as a traditional
table saw (see
Figure 103). Smaller, lighter boards
are easier to slide across the stationary cast iron
table surface to the right of the saw blade.
Rip
Fence
Workpiece
Figure 103. Traditional rip cut with rip fence.
The edge shoe (see
Figure 102) is used to
stabilize the front end of a workpiece when
otherwise unsecured.
2. Check to make sure fence is at 0°, and if
necessary, adjust it as described in
Squaring
Crosscut Fence to Blade on Page 79.
3. Adjust distance between crosscut fence and
blade (refer to
Page 54 for further details).
4. Set a flip stop to desired width of cut.
5. Position blade guard according to height of
workpiece. (Refer to
Understanding Blade
Guard on Page 44.)
6. Load workpiece onto table saw. The setup
should look similar to
Figure 102 on Page
55.
7. Take all necessary safety precautions, then
perform cutting operation.
Figure 104. Stop block against 0° stop bolt.
0° Stop Bolt
& Block
Summary of Contents for G0764
Page 22: ...20 Model G0764 Mfd Since 02 14 Hardware Recognition Chart...
Page 124: ......