Grizzly G0764, Owner'S Manual, Page: 55 / 124

Model G0764 (Mfd. Since 02/14)
-53-
Crosscut
Table
Crosscut
Table
Inside
Position
Crosscut
Table
Outside
Position
Figure 93. Inside and outside support bar
positions.
Setting Up Crosscut
Fence
Before using the crosscut fence to perform
cutting operations, it must be setup properly.
This includes positioning the crosscut fence on
the crosscut table, adjusting the support bar,
adjusting the crosscut fence distance from the
blade, and positioning the crosscut table along
the sliding table.
The crosscut fence can be mounted in the front
or rear position (see
Figure 92) depending upon
the size of the workpiece and which position will
provide the safest operation. The support bar
is adjusted accordingly for maximum workpiece
support.
Front
Position
Crosscut
Table
Support
Bar
Rear
Position
Crosscut
Table
Support
Bar
Figure 92. Crosscut fence front and rear table
mounting positions.
Whenever the crosscut fence is moved between
the front and rear positions, you must verify the
fence is square to the blade, and the 0° stop bolts
are properly adjusted before using the fence.
Refer to
Squaring Crosscut Fence to Blade on
Page 79 for further details.
Positioning Crosscut Fence
To position crosscut fence:
1. DISCONNECT MACHINE FROM POWER!
2. Unthread and remove knob bolts shown in
Figure 94.
Figure 94. Locations of knob bolts securing
crosscut fence.
Knob Bolts
The support bar can also be installed in either the
inside or outside positions (see
Figure 93).