Grizzly G0542, Instruction Manual

Page: 22 / 32

-20- G0542 48" Pan and Box Brake
This section is designed to help the operator with
adjustments that were made at the factory and
that might also need to be made during the life of
the machine.
This section is provided for your convenience—
it is not a substitute for the Grizzly Service
Department. If any adjustments arise that are not
described in this manual, then feel free to call the
Grizzly Service Department at (570) 546-9663.
Similarly, if you are unsure of how to perform
any procedure in this section, the Grizzly Service
Department will be happy to guide you through
the procedures or help in any other way.
Aligning Bending
Wing
Figure 27.
Callouts showing where clamp block
and bending wing must be flush.
In order to achieve accurate bends, the top sur-
face of the bending leaf and the attached bend-
ing wing must be flush with the top surface of the
clamp block when the bending leaf is in the down
position (see
Figure 27
).
Check for proper alignment by examining how the
edges of each component meet each other. Only
perform the instructions below if the top surfaces
of these components are NOT flush with each
other.
Clamp
Block
Must Be
Flush Here
Bending
Wing
There are two adjustments that can be made to
align the clamp and bending wings. First, you
can adjust the ends of the bending leaf to make
it even with the clamp block; and second, you
can straighten the main body of the bending leaf
or clamp block by tightening a large nut on the
center of a truss assembly, which is mounted to
each.
Tools Needed: Qty
18MM Wrench or Socket ................................... 1
8MM Hex Wrench .............................................. 1
27MM Wrench or Adjustable Wrench ............... 1
About Service
SECTION 7: SERVICE ADJUSTMENTS