Grizzly G0542, Instruction Manual

Page: 18 / 32

-16- G0542 48" Pan and Box Brake
The fingers can be spaced apart for clear-
ance when making pans or boxes. This requires
removing one or more of the fingers so that you
can space the others to match the width of your
pan or box (see
Figure 21 ).
Figure 20. Setback adjustment knob (one of
two) for clamping leaf.
Figure 22. Top cap screw for loosening finger to
slide off front guide.
Figure 21.
Fingers spaced apart to allow
clearance of pan or box sides.
Spacing Fingers
Front Guide
Top Cap Screw
2.
Loosen the top cap screws of the fingers you
need to move, and slide them across the
front guide so that you have adequate room
for your workpiece on both sides. Note—
You
may need to mix and match finger widths to
equal the size of your workpiece.
3. Align the fingers and tighten the cap screws.
(See page 14 for alignment instructions.)
Tools Needed: Qty
8MM Hex Wrench .............................................. 1
To space the fingers apart:
1.
Remove one of the end fingers by loosening
the top cap screw, shown in
Figure 22 , and
sliding it off the front guide.