Grizzly G0542, Instruction Manual

Page: 23 / 32

G0542 48" Pan and Box Brake -21-
Figure 28. Bending leaf mounting bolts.
Figure 29.
Bending leaf adjustment cap screw.
Figure 30.
Truss nut.
To align the clamp and bending wings:
1. Loosen the bending leaf mounting bolts on
each end of the brake (see
Figure 28
).
2. Use the bending leaf adjustment cap screws
shown in
Figure 29
to align the bending leaf
flush with the clamp bar.
4. Examine the center area where the clamp
block and bending wing meet.
— If the bending wing is lower than the
clamp block, then the truss nut under the
bending wing needs to be tightened,
— If the bending wing is
higher
than the
clamp block, then the truss nut under the
clamp block
needs to be tightened.
5.
Tighten the appropriate truss nut (
Figure 30
)
as determined from step 4 until the bending
wing and the clamp block are flush with each
other in the center. Note—
Make sure the
truss nuts remain tight, because they help
stiffen the the leaf they are attached to.
3.
Tighten the bending leaf mounting screws.
— If the entire length of the bending leaf is
flush with the clamp block, then no further
adjustments are necessary.
— If the bending leaf is flush with the clamp
block at both ends but is not flush in the
center, then proceed to
step 4
.