Climber 10
/ Translation of the original instructions
THE MACHINE DOES NOT REMAIN IN NEUTRAL POSITION
Set the forward lever into neutral position and adjust the rod located under the seat on the right side,
by loosening or fastening it until both wheels stop (fig. 32). This procedure must be carried out with
wheels lifted from the ground. To adjust the speed in both forward and reverse gears use the screws
(fig. 31).
END OF WORK
After mowing, disengage the blades and drive back with the cutting deck in the highest position. To
stop, set the forward lever into STOP position, set the throttle lever at minimum rpm, switch off the
engine by turning the key to STOP position (fig. 1, n. 1), set the cutting deck at the lowest position and
engage the parking brake.
CLEANING
Clean the outside of the mower after each use. Use compressed air. Do not wash neither the engine
nor the electric components of the machine with a high-pressure water jet machine.
STORAGE AND PROLONGED PERIODS OF DISUSE
Store the mower in a dry place, away from atmospheric agents, and preferably cover with a sheet. If
the mower is not going to be used for a long period (over 1 month), disconnect the red battery cable
and follow the instructions described in the engine manual. Also lubricate all of the articulated joints.
Regularly check that the battery voltage does not drop below 12 volts. If it does, recharge the battery.
If the machine is to be out of use for more than 30 days, drain the fuel from the engine to prevent
sticky deposits from forming in the fuel intake system or in vital parts of carburettor. To protect the
engine we recommend that you pour the preservative additive for unleaded petrol into the tank. Run
the engine a while to let the additive circulate through the carburettor. Important: If petrol is used
which contains alcohol too, drain the fuel tank and run the engine until there is no fuel left.
TRANSPORTING THE MACHINE
Should the machine be transported on lorries or trailers, firmly secure it using ropes. Check the wight
of the machine on the label and use appropriate lifting means.
17
Summary of Contents for AWD 22
