50
Putting into service
During the first use, you should wash the filter (check the filer system maintenance).
Filtering is a mechanical treatment that allows cleaning the pool water by means of eliminating the impurities and contaminating
particles.
The hydraulic circuit and water purifying group is an essential element for the optimal operation of the filtering system.
The filtering system should be coherent: The filter dimensions should be proportionate to the volume of water in the pool and to
the pump performance.
The filtering is not anti-bacteria Therefore, you should add a product (or a system) for disinfection of the water.
FILTERING TIME:
During the period of use of the pool kit, the filtering system should be used every day, for sufficient time to guarantee a complete
renovation of the entire volume of water.
Theoretically, this the calculation:
(Water Temp / 2) = equals the filtering hours
Often, it is more practical to filter 4 hours before and 4 hours after use.
WATER TEMPERATURE
FILTERING TIME FOR ONE DAY
15 a 18°C
8 hours
19 a 21°C
10 hours
22 a 25°C
12 hours
26 a 28°C
14 hours
28 a 30°C
19 hours
+ de 30°C
24 hours
We do not recommend intermittent operation (stopping and starting every hour) because not all the water volume will be
renovated.
OPERATION PRINCIPLE:
The skimmer sucks the water from your pool (this element and especially the basket that collects leaves and other large
impurities, should be very clean).
The water is then sent through the tubes to reach a pump with pre-filter * (there another basket filters medium impurities, therefore
its cleanliness is essential for good operation).
The pump sends the water towards a filter that retains all the suspended impurities thanks to its filtering material. This is a sand
filter. The filtered water returns to the pool. This unit can be manipulated, programmed and protected using an electrical unit
(optional).
The water from your pool should be subject to physical and chemical treatment to keep its transparency and to guarantee a
completely safe bath.
We do not recommend filling to the pool with well water, to avoid all types of chemical reaction and water colouring risks.
YOU SHOULD ALWAYS MAKE SURE THAT::
1. The water level is correct: that is to say, slightly above half of the skimmer.
2. The skimmer and pump pre-filer baskets are clean.
3. The hydraulic circuit is controlled and the flap positions verified.
4. The filter can be started and the pressure controlled with a pressure gauge (according to the type and the position of the
technical location regarding the pool).
HAVING ACCESS TO THE POOL IS PROHIBITED IN THE CASE THAT THE FILTER SYSTEM IS
DETERIORATED
* According to model
Summary of Contents for KWOV436
Page 2: ......