GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
#0060376
Keine Haftung für Druckfehler. Technische Änderungen vorbehalten! No liability for printing errors. We reserve the right to introduce
modifications. Sous réserve de modifications! Nous ne sommes pas responsables d’éventuelles erreurs d’impression!
03/2009
20
Assembly instructions
•
Assemble the boatstand by fitting together the front
support (part 1), the rear support (part 2) and the
side panels (part 3); take care to glue the joints
securely. Paint the finished stand when the glue is
dry, and apply the self-adhesive foam tape (part 4)
to the contact surfaces (not shown in the photo).
The tape avoids scratches to the painted hull.
•
Assemble the keel / mast socket (part 5).
IMPORTANT:
don’t follow the outside shape of the
vacuum-moulded parts when gluing the parts
together. It is the inside area, which accepts the
keel, which is important: the sides must be exactly
parallel, otherwise the keel will not fit properly later.
Note: For the version 2014.C the keel / mast socket
must be corrected at the top and at the bottom by
0.5 mm for better fitting.
•
Glue a mast support reinforcement (part 6) on each
side of the keel / mast socket on the underside, at
the position of the semi-circular lugs.
•
Glue together the two servo mount supports (part
7), and adjust the slot for the keel / mast socket so
that the supports are an easy sliding fit on the
socket. Note: For the version 2014.C the gap in-
between should be processed for approx. 1 mm.
Glue this assembly to the keel / mast socket,
aligned exactly as shown; the dimensions are
stated on the plan.
NOTE:
one of the supports has
a deeper slot for the keel / mast socket; this part
should face down.
•
Glue the completed keel / mast socket in the hull
(part 8), taking care to position it accurately. Apply
a fillet of UHU acrylit all round on the underside, to
ensure that the socket is completely watertight.
•
Sand back the bow reinforcement (part 9) until it is
an easy, snug fit in the tip of the bow. Glue the
reinforcement in place securely using UHU acrylit.
NOTE:
take care to position the reinforcement
accurately, as the central girder (part 25) must rest
on it later.
•
Glue one of the rudder bush reinforcements (part
10) over the hole for the rudder bush.
•
Glue the two reinforcements for the sail servo (part
12) and the reinforcement for the jib trim servo
