05
33601 VARIO Modul - Graupner HoTT 2.4
Display (Set Warning):
shows the various „display pages“ with the possible adjustable parameters and the
associated adjustable warning thresholds (page 1, page 2, etc.). To switch between pages, press the INC
or DEC key (
or
).
Factory Set:
choosing „YES“, will reset the settings of the variable module to factory settings.
The following parameters can be set separately for all displays:
Warning Time:
sets whether and how long the warning signal is activated when reaching a certain value
for each display screen.
Repeat Time:
sets how often the warning signal is activated when reaching a certain value for each display
screen.
Signal Tone:
sets the signal tone melody. The warning sounds are combined with the warnings on the
display and the voice output. Therefore, they may not be changed.
Overview of the signal tones on page 13.
When a warning is activated, the corresponding message (eg. Min. Height) is shown inverted in the
fi
rst row of the associated display, which then appears alternately with the display VARIO SENSOR
and the selected Signal Tone A - Z sounds.
You can stop the warning at any time by pressing one of the buttons on the top of the SMART-
BOX.
If you wish to carry out an adjustment (point 4.2 to 4.7) you must use the INC (
) or DEC (
) buttons
above the screen to select „page 1 - Save Sensor“. Simultaneously pressing the INC and DEC buttons
(
SET
) switches the parameter to be adjusted to inverse video (white on black); this indicates that it can be
programmed: pressing the INC (
) button at this point increases the value to YES. When the adjustment is
complete, save the selected setting by pressing the INC and DEC buttons (
SET
) simultaneously; the dark
background now disappears in order to con
fi
rm this action.
If you do not want to save the adjustments, select NO.
Warning:
• Do not carry out any programming work on the sensors while the model is
fl
ying, otherwise there is a real
risk that your model will
fl
y out of control while you are not concentrating on it!
• If your model is
fi
tted with two or more receivers, it is absolutely essential that you do not carry out pro-
gramming work during a
fl
ight, as this can alter the settings in the receivers to which no telemetry equip-
ment is connected; in the worst case this could result in the model crashing.
For this reason always carry out programming on the ground, and check that only the receiver with con-
nected sensors is powered on.
