GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Modifications reserved! No liability for printing errors. Id.-No. 0062205 06/2011
9
Installing the receiver and LiPo flight pack
The first step is to connect the servo leads to the receiver; we suggest the following
sequence: speed controller to socket 1, left aileron servo to socket 2, elevator servo
to socket 3, rudder servo to socket 4, right aileron servo to socket 5. It is a good idea
to connect 100 mm extension leads to sockets 2 and 5 permanently, as this makes it
much easier to plug in the aileron servos when you rig the model. Deploy the receiver
aerials to the outside of the fuselage, keeping them at 90° to each other, and fix them
in place with clear tape.
Slide the LiPo flight battery into place as shown, and connect it to the speed con-
troller.
Check all the model’s working systems in turn from the transmitter. Maximum control
surface travels: 30 mm each way for ailerons, 45 mm each way for elevator, 75 mm
each way for rudder, all measured at the inboard or bottom end of the trailing edge.
When you are satisfied, install the spinner and propeller as described earlier.
Decals
If you decide to use the GRAUPNER decals, there is no need to paint the
SOLIDPOR® components. If you opt for the LEKI decal version, you should first paint
the model overall using GRAUPNER LEXACOLOR spray paint, Order No. 945.2, or
spray paint, Order No. 928.2. Do not sand or rub down the SOLIDPOR® surfaces;
simply wipe them with Spannfix (cellulose) thinners before applying the paint. The
