GRASS VALLEY XIP-3901, User Manual

Page: 185 / 308

185
XIP - 3901
User Manual
Senders Panel
The Senders panel has three tabs ( UDC1 , UDC2 , and Advanced ); UDC1 and UDC2 are for
each of XIP - 3901 - UDC - IF’s independent processing UHD channels. These tabs configure the
SMPTE ST 2110 outputs. The
Advanced
tab allows you to configure the outgoing payload
type and DSCP priority.
This panel is available when the card’s
Operating Mode
in the
Factory Presets
panel is set
to the SDI and IP Hybrid option. See Setting the Card’s Operating Mode , on page 169 for
more information.
UDC1 / UDC2 Tabs
These tabs allow you to configure the destination media’s video format, audio channels,
and the SMPTE ST 2110 output stream’s IP addresses and port numbers. The configuration
of the UDC2 tab is the same as the UDC1 tab. Only the configuration of the UDC1 tab is
shown below.
Each processing channel (
UDC1 / UDC2 ) can:
• Send one SMPTE 2110-20 video streams ( Video 1 ).
• Send full ancillary space on one SMPTE 2110-40 metadata stream ( Meta 1 )
• Send 4 audio streams (
Audio 1
to
Audio 4
)
• Audio 1 can send up to 64 processed audio channels.
• Audio 2 to Audio 4 can send up to 64 audio channels, but only audio channels 1 to
16 are processed audio channels. Audio channels 17 to 64 will contain silence.
Statuses confirm that the RTP stream is successfully streaming.
Property Description
Media The background shows the current media status:
Green: No error
Red: Error
Grey:
Inactive
Stream Shows the primary (ETH1) and secondary (ETH2) stream receiver status:
Green: No error
Red: Error
Grey:
Inactive
Error Shows the number of packets in error that will required SMPTE 2022-7 reconstruction for
each Ethernet port.
Reconstruction
Error
Shows if the redundant stream was successful at maintaining signal integrity for the
previous 5 seconds, when primary (ETH1) and secondary (ETH2) ports are enabled.
Reset Counters Clears the number of errors shown above. When Reset is clicked, the current date and
time is shown as a record of how long the error counters have been running since the
last reset.