GRASS VALLEY XIP-3901, User Manual

Page: 124 / 308

124
Configuring the XIP - 3901 - UDC - IP v1.2 Application with iControl
Receivers Panel
Receivers Panel
The Receivers panel has two tabs ( UDC1 and UDC2 ); one for each of XIP - 3901 - UDC - IP’s
independent processing channels. The configuration of the UDC2 tab is the same as the
UDC1 tab. Only the configuration of the UDC1 tab is shown below.
Property Description
Mode Set the NMOS mode:
IS-04 : enable the Networked Media Open Specifications (NMOS) IS-04 v1.2 or higher for
device discovery and registration. All senders will publish and update SDP file, but
receivers can't be updated.
IS-04 & IS-05 : enable the NMOS IS-04 for device discovery and registration and IS-05 for
connection management. All senders will publish and update an SDP File and receivers
will accept routing request and process the received SDP file.
OFF : disable NMOS. This eliminates the RED status when NMOS IS-04 is not used.
This is the default.
Label Set the identifier by which this XIP - 3901 - UDC - IP card will be known in the NMOS registry,
and by extension, to other NMOS devices using this NMOS registry.
Registration
Status
Shows if the card has successfully registered itself in the NMOS registry.
Green:
the card has successfully registered itself with the NMOS registry.
Red: the card is not yet registered with the NMOS registry.
Grey: NMOS is disabled ( Mode is OFF).
Registry IS-04,
Registry Mode
Set the IS-04, Registry Mode:
Auto
: automatic discovery of the NMOS registry using DNS Service Discovery (DNS-SD), as
described in AMWA IS-04 NMOS Discovery and Registration Specification v1.2.
Static
: manually specified NMOS registry values for address, registration port and query
port. In this mode, by specifying a registry address in the same subnet as one of the
interfaces, the interface will be used. However, when specifying an address in a different
subnet, the first available interface will be used in the following order: FRM , ETH3 , ETH1 ,
and then
ETH2
.
The default Registry Port value is 3210. The default Query Port value is 3211.
HTTP Address Set the NMOS registry’s IP Address when the Registry IS-04, Registry Mode is Static .
Registration
Port
Set the NMOS registry’s registration port number when the Registry IS-04, Registry Mode
is Static .
Query Port Set the NMOS registry’s query port number when the Registry IS-04, Registry Mode is
Static .
Group Tag Hint Set which audio receiver/sender to include in the Group Hint Tag. By Default GV
Convergent creates logical source/destination groups with only one audio stream. If you
want to have more audio receivers in a source/destination group, you will have to create
them manually in GV Convergent.