GRASS VALLEY KARRERA K-FRAME, Installation & Service Manual

Page: 221 / 278

KARRERA K-FRAME — Installation & Service Manual 221
Software Installation
2. Select
IP Addr
(press
Lrn
) to enter IP address mode ( Figure 161 , right).
3.
Select
Panel Boot
(press the
Bank 3/7
), then select
Yes
(press
7
) to reset the
Control Panel ( Figure 159 ).
Figure 159. Karrera Panel Reset, EMEM Area
The Control Panel reset procedure using the EMEM area performs a con-
trolled shut-down of the panel software and then reboots the operating
system. This is the safest method of resetting the panel.
CAUTION The Reset button inside the Karrera Control Panel, located on the processor
board under the air guide, performs a hard reboot of that panel’s single board
computer (equivalent to turning the power switch off and on). The
Reset
button does not properly shut-down the panel software, and should only be
used in the rare situation where the EMEM area Reset procedure is not oper-
ational.
Software Installation
Karrera K-Frame systems are shipped with the current software version
installed. Updates to GV Switcher system software are available for down-
load from the Grass Valley website. Software installation tools are provided
with each update package.
Refer to the separate Karrera K-Frame Release Notes for complete software
installation instructions.
Software Option Authorization
Introduction
Some Karrera K-Frame system options have software components that can
be enabled via an authorization process, using authorization codes. Autho-
rization codes are also used for tracking maintenance contracts.
9 Ba n k a n k
3 / 7
7 8 L rn
IP Address Setup
Panel
Boot
Panel
Sub
Panel
IP
Frame
IP
9 Ba n k a n k
3 / 7
7 8 L rn
Panel Reboot
Are you sure?
Yes
Gateway
No
8804_11