GRAPHTEC CELITE-50, User Manual

Page: 85 / 128

5-7
Chapter 5 Detailed Settings
5.3
Adjusting the Cutting Time
The cutting time can be adjusted by setting the "cutting speed", "speed when starting the cut (acceleration)",
and "moving speed when the tool is lifted".
As setting a speed that is too fast can affect the cutting quality, set values that suit the type of tool and media
to be used.
Once you are done with the settings, touch the (Exit) to return to the "HOME" screen.
Setting the Speed
Set the cutting speed.
Although setting a faster speed will shorten the cutting time, doing so may also lower the quality of the finish.
Configurable values: 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 15, 20, 25, 30, 35, 40, 45, 50
1.
Touch the (CONDITION) on the
"HOME" screen to open the CONDITION
NO. setting screen.
2.
Select the CONDITION NO. to set by using
the " " and " " and touch the "SPEED".
3.
Use the " " and " " to select the speed
and confirm the selection with the
(Confirm).
Setting the Acceleration
Set the acceleration. This setting is applied to all operations when starting the cut after the tool has been lowered.
Although setting a greater value will shorten the cutting time, doing so may also lower the quality of the finish.
Configurable range: 1 - 2
1.
Touch the (CONDITION) on the
"HOME" screen to open the CONDITION
NO. setting screen.
2.
Select the CONDITION NO. to set by
using the " " and " " and touch the
"ACCELERATION".
3.
Use the " " and " " to select the
acceleration and confirm the selection with
the (Confirm).