GRAPHTEC CELITE-50, User Manual

Page: 61 / 128

4-9
Chapter 4 Convenient Functions
4.2
Cutting using the Carrier Sheet
lthough the carrier sheet (PM-CM-003) makes it possible to cut out the following media.
•
When cutting (cutting out) media without a backing.
•
When cutting out media (die cutting).
•
Media smaller than A4-sized sheets (Do not use media smaller than the postcard [100 × 148 mm]).
Precautions
•
lthough the carrier sheet is made to be re-peelable, the sheet will warp and lose its adhesion along with use.
In such case, replace with a new carrier sheet.
•
As media to attach to the carrier sheet, use media recommended by Graphtec.
When using commercially available inkjet media, media coated on both sides cannot be used.
When using inkjet media that is coated on a single side, attach the side that is not coated onto the carrier
sheet. Attaching the coated side will lower the adhesion of the carrier sheet and may void the carrier sheet of
use.
•
When removing media from the carrier sheet after it has been cut, be sure to remove the media slowly and
carefully.
•
As the adhesive portion of the carrier sheet is of a design that easily absorbs moisture, refrain from taking it
out of the bag until right before use.
•
When storing the carrier sheet, attach the separator removed before use onto the adhesive surface and
place it in the bag for storage.
•
Refrain from storing the carrier sheet in a location subject to high temperature, high humidity, and direct
sunlight.
•
When using media with excellent smoothness (no roughness), traces of curling may be left on the media
when it is removed.
•
Thin media such as copying media may tear upon removal or may even be impossible to remove.
Cutting Area and Cutting Direction
The adhesive area of the carrier sheet, cutting area, and cutting direction are as shown below.
Carrier Sheet
330.2mm
10mm
35mm
483mm
10mm 10mm
Cutting Area
Adhesive Area
X
Y