Warnings
3A2776K
5
Warnings
The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The
exclamation point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific risks.
When these symbols appear in the body of this manual or on warning labels, refer back to these Warnings.
Product-specific hazard symbols and warnings not covered in this section may appear throughout the body of this
manual where applicable.
DANGER
SEVERE ELECTRIC SHOCK HAZARD
This equipment can be powered by more than 240 V. Contact with this voltage will cause death or
serious injury.
•
Turn off and disconnect power at main switch before disconnecting any cables and before servicing
equipment.
•
This equipment must be grounded. Connect only to grounded power source.
•
All electrical wiring must be done by a qualified electrician and comply with all local codes and
regulations.
WARNING
SPECIAL CONDITIONS FOR SAFE USE
•
Potential risk of electrostatic discharge. See instructions for guidance to minimize the risk of elec-
trostatic discharge.
•
The system must be earthed using copper conductors according to the installation instructions. All
intrinsically safe circuits must be connected to ground at one point.
•
For information on the required dimensions of the flameproof joints contact the holder of this certifi-
cate (Graco Inc.); Flame-path joints are not intended to be repaired.
•
Special fasteners for securing equipments covers on the flameproof heaters shall have a minimum
yield strength of 1,100 MPa and be corrosion resistant and sized M8 x 1.25 x 30.
FIRE AND EXPLOSION HAZARD
Flammable fumes, such as solvent and paint fumes, in
work area
can ignite or explode. Paint or
solvent flowing through the equipment can cause static sparking. To help prevent fire and explosion:
•
Use equipment only in well ventilated area.
•
Eliminate all ignition sources; such as pilot lights, cigarettes, portable electric lamps, and plastic drop
cloths (potential static sparking).
•
Ground all equipment in the work area. See
Grounding
instructions.
•
Never spray or flush solvent at high pressure.
•
Keep work area free of debris, including solvent, rags and gasoline.
•
Do not plug or unplug power cords, or turn power or light switches on or off when flammable fumes
are present.
•
Use only grounded hoses.
•
Hold gun firmly to side of grounded pail when triggering into pail. Do not use pail liners unless they
are anti-static or conductive.
•
Stop operation immediately
if static sparking occurs or you feel a shock
.
Do not use equipment until
you identify and correct the problem.
•
Keep a working fire extinguisher in the work area.
