Additional Repair and Replacement Instructions
332203F
35
3.
Remove large bolts (18) holding latch assembly (21)
to base (1) (F
IG
. 76). Discard latch assembly.
Latch Reassembly
1.
Align latch assembly (21) with reel base (1) and ori-
ent it as shown in F
IG
. 76.
2.
Replace bolts (18).
3.
Wrench tighten bolts. Then torque to 24-35 ft. lbs
(33.9 to 46.45 N.m).
4.
Remove c-clamp installed in Latch Disassembly,
Step 2.
Adjusting Spring Tension
If the hose cannot be pulled all the way out or if it does
not retract all the way back onto the hose reel, you need
to adjust the spring tension.
1.
If the hose reel has been in service, relieve pres-
sure, page 10.
2.
Pull the hose out far enough to engage the latch.
NOTE:
Listen for the loud click when the spool has
latched.
3.
Attach a c-clamp (A) to the reel spool as shown in
F
IG
. 77 to help prevent the reel from unintentionally
becoming unlatched and spinning freely.
If a ball stop and dispensing device are
NOT
installed on
the hose end, skip Step 4 and continue instructions with
Step 5.
F
IG
. 76
21
18
1
•
Never allow the reel to spin freely. Doing so
causes the spool to spin out of control, which
could cause serious injury if you are hit by the
hose or dispense valve.
• Always wear heavy, non-slippery gloves when
adjusting the spring tension to protect your hands
from being cut on the hose reel.
F
IG
. 77
(A)
A