Hose Reel Reassembly
332203F
19
Hose Reel Reassembly
1.
Install swivel (3) inside spool on the
inlet side.
NOTE:
The swivel (3) must be installed on the cor-
rect side of the spool (2) and oriented correctly
inside the spool to ensure correct hose reel opera-
tion.
a.
Slide the swivel through the hole in the center of
the spool and rotate the swivel until flat surface
(3a) is as parallel as possible to the floor.
b.
Temporarily install one bolt (4) through a hole to
hold the swivel in the installed position (F
IG
. 28).
c.
Rotate the spool (2) until the flat surface (3a) of
the swivel is parallel to the floor or table top and
matches F
IG
. 27, Top View, Correctly Installed
Swivel and Outlet illustration. This is how your
swivel should look inside the spool when it is
correctly installed.
d.
Mark the position of the missing threaded screw
hole (a) (F
IG
. 28) on the swivel to use as a refer-
ence for lining up the ratchet (31) for installation
in Step 2, page 20.
Notice the location of swivel (3) in Ref. B in the
Correctly Installed Swivel and Outlet illustration
(F
IG
. 27). This is the correct swivel (3) installa-
tion position.
Ref. C shown in the Incorrectly Installed Swivel
On the Wrong Side of the Spool illustration (F
IG
.
27) shows the appearance of the swivel (3)
inside the spool when it is incorrectly installed.
F
IG
. 27
3
Ref. B
Top View
Section View A-A, Showing Outlet Installed Correctly
3
A
A
Ref B
Ref. C
3
Top View
Correctly Installed Swivel (3) and Outlet
Incorrectly Installed Swivel (3) On the
3a
Wrong Side of the Spool (2)
F
IG
. 28
a
4