Hose Reel Disassembly
332203F
11
Hose Reel Disassembly
NOTE:
•
Throughout these instructions the inlet-side refers to
the side of the spool the fluid inlet (6) is installed.
The spring-side refers to the side of the spool the
spring (10) is installed.
•
Additional procedures are provided at the end of the
Hose Reel Disassembly section of this manual.
1. Relieve pressure, page 10.
2. Disconnect inlet hose (a) from inlet (6).
3. Pull out enough hose to perform flush-
ing procedure (Step 7, page 12).
4. Engage latch.
Securely attach a c-clamp (A) to the reel spool abut-
ting frame, as shown in F
IG
. 3, to help prevent the
reel from unintentionally becoming unlatched and
spinning freely.
5. Remove dispense valve and ball stop.
To remove ball stop: remove nuts (47), screws (46) and
ball stop (45) from end of hose (F
IG
. 4).
If you are only replacing the ball stop, stop disas-
sembly instructions here.
Ball Stop Kits: 218341, 222225, 237872, 24R060,
24R061 are available from Graco. Ball stop reassem-
bly instructions are provided in Step 14, page 26.
6.
If you are not replacing the ball stop, set these
pieces aside to use for reassembly.
•
Always wear heavy, non-slippery gloves to protect
your hands from being cut on the hose reel.
• Never allow the reel to spin freely. Doing so
causes the spool to spin out of control, which
could cause serious injury if you are hit by the
hose or dispense valve.
F
IG
. 2
6
a
F
IG
. 3
F
IG
. 4
A
45
46
47