Hose Reel Disassembly
12
332203F
7. Flush fluid from reel and hose.
a.
Place end of hose in a waste container.
b.
Blow out entire lubricant supply line with air.
c.
Cap end of hose to prevent fluid spills.
8. Remove Hose Reel From Service.
The hose reel must be taken out of service to perform
some of the repair and service procedures described in
this manual.
Refer the following Procedures Table to identify which
procedures do not require the hose reel be taken out of
service before you perform the repair or maintenance
procedure and those that do require the hose reel be
taken out of service.
For procedures that do not require the hose reel is taken
out of service, skip Step 8a - b and continue hose reel
disassembly instructions with Step 9, page 13.
Procedure Table
a.
Unbolt reel and remove it from mounting loca-
tion.
NOTE:
For overhead installations always use a hoist or
other suitable lifting device to raise or lower hose reel
position.
Secure a lifting strap around spool as shown in F
IG
. 7.
See Technical Data (page 44) for hose reel weights.
F
IG
. 5
F
IG
. 6
Procedure
Un-install
Reel
Reel
Installed
Remove dispense valve and ball
stop
X
Add/Remove spring tension
X
Remove /Replace spring canister
X
Remove/Replace outlet and seals
X
Remove/Replace inlet and seals
X
Remove/Replace bearings
X
Remove/Replace ratchet
X
Remove spool from frame
X
Remove shaft from spool
X
Remove/Replace hose
X
Replacing roller guide
X
Replace latch
X
F
IG
. 7