![background image](http://html1.mh-extra.com/html/graco/saniforce-sdu-a01aaa1aa0c21/saniforce-sdu-a01aaa1aa0c21_manual_2251594042.webp)
Electro-pneumatic Control Panel Display Screens
ELECTRIC
ELECTRIC
ELECTRIC SHOCK
SHOCK
SHOCK HAZARD
HAZARD
HAZARD
To reduce the risk of electric shock when accessing
the electrical enclosure while power is present:
• All electrical work must be done by a qualified
electrician.
• Wear appropriate personal protective equipment.
Event
Event
Event Type
Type
Type
Event
Event
Event Description
Description
Description
Error
Error
Error
Code
Code
Code
Cause
Cause
Cause
Fix
Fix
Fix
Alarm
Communication bus
power error
V1CC
Communication bus has lost power
Restore power to communication bus
Alarm
Control panel supply
pressure low
P1PS
Control supply pressure sensor
reads pressure less than the
minimum 30 psi required for
operation or less than 5 psi below
largest pressure required by the
current recipe
Increase supply air pressure or reduce
pressure required by the current recipe
Alarm
Control supply
pressure sensor
error
WMPC
Control supply pressure
sensor reports an error
Check control supply pressure sensor
and wiring
Alarm
Emergency stop or
I/O power error
V1CE
I/O has lost power
Restore I/O power, reset E-stop button
Alarm
External interlock #1
open
EBN1
Interlock #1 is enabled and tripped
Close or disable interlock #1
Alarm
External interlock #2
open
EBN2
Interlock #2 is enabled and tripped
Close or disable interlock #2
Alarm
Laser position sensor
error
WMCL
Laser sensor reports an error
Check Laser sensor and wiring
Alarm
Laser sensor
obstructed
L9CL
An obstruction or unintended target
of the position sensor has been
detected
Ensure the laser has a clear line of sight
to the target
Alarm
Network
Communication Error
CC0R
Remote network communication
is enabled, but the remote device
cannot be found
Verify that the IP addresses of the
system and the remote controller are
correct. Verify that the system and
the remote controller are on the same
network. Verify that the remote controller
is properly configured as described in
.
42
3A5402J