Graco SaniForce SDU A01AAA1AA0C21, Manual

Page: 43 / 76

Electro-pneumatic Control Panel Display Screens
Event Event Event Type Type Type Event Event Event Description Description Description
Error Error
Error
Code
Code Code Cause Cause Cause Fix Fix Fix
Alarm Network Initialization
Error CA0R An error occurred while
initializing the system for network
communication Restart the system. Contact Graco
Support if the problem persists.
Alarm Network Interlock
Open EB0R The network interlock is tripped
Ensure proper output from the remote
controller or disable the remote
connection.
Alarm Pump supply
pressure low P1PP Pump supply pressure sensor
reads pressure more than 5 psi
below the pressure being driven Increase supply air pressure or reduce
pressure required by the current recipe
Alarm Pump supply
pressure sensor
error WMPP Pump supply pressure
sensor reports an error Check pump supply pressure sensor and
wiring
Alarm Ram movement
timeout EU1R Upward ram movement has not
reached the minimum height
when the ram movement timeout
completes Check ram for obstructions to movement,
manually raise ram
Alarm Seal inflation timeout EU1S Seal has not inflated to within 1.0
psi of the value being driven when
the seal inflation timeout completes Check seal and air lines
Alarm Seal not deflated P71S Seal pressure sensor does not
read the seal is depressurized after
seal deflation timeout completes Check seal, manually deflate seal, adjust
Seal Deflate Time in recipe
Alarm Seal pressure sensor
error WMPS Seal pressure sensor reports an
error Check seal pressure sensor and wiring
Alarm Software Error WX00 Unexpected state detected in the
software Acknowledge the alarm. If the alarm is
triggered regularly, contact Graco
Alarm X20AO2622 analog
output module error WMCA X20AO2622 module reports an
error Check X20AO2622 module and wiring.
Verify that the modules are installed in
the proper locations*.
Alarm X20BC1083 bus
coupler module error WMCB X20BC1083 module reports an
error Check X20BC1083 module and wiring.
Verify that the modules are installed in
the proper locations*.
Alarm X20CM8281 mixed
module error WMCC X20CM8281 module reports an
error Check X20CM8281 module and wiring.
Verify that the modules are installed in
the proper locations*.
Alarm X20DO8322 digital
output module error WMCD X20DO8322 module reports an
error Check X20DO8322 module and wiring.
Verify that the modules are installed in
the proper locations*.
Alarm X20DS438A IO-LINK
module error WMCS X20DS438A module reports an
error Check X20DS438A module and wiring.
Verify that the modules are installed in
the proper locations*.
Alarm X20PS9400 power
supply module error WMCP X20PS9400 module reports an
error Check X20PS9400 module and wiring.
Verify that the modules are installed in
the proper locations*.
Deviation File not found WSU0 The file targeted by a USB Import
could not be found. Verify the file name is correct (has not
been changed from the name given
during a USB export) and that it is located
within a directory named "SDU-[serial
number]".
Deviation Position sensor dirty L2CL Position sensor reflectivity value is
low. Ensure the laser sensor and target are
clear of debris.
3A5402J 43