Graco President 232090, Instructions-Parts List Manual

Page: 11 / 28

308770 11
Installation
Installing the Heater Module
NOTE: Refer to Fig. 3, and to the Dimension drawing
on page 26 and the Mounting Hole Layouts on page
27.
1. Position the heater bracket (205) to the right of the
pump bracket (22), at the same height. The two
slots must face up. The center of the two outer left
holes must be no more than 9 in. (228 mm) from
the right edge of the pump bracket. See page 27.
2. Check that the heater bracket (205) is level. Using
the bracket as a template, mark the four outer
holes on the wall. The four outer holes are used to
mount the bracket to the wall, and the two inner
slots and two inner holes are to mount the heater
(201) to the bracket.
3. Drill four holes in the wall.
4. Bolt the bracket (205) to the wall with 1/2 in. bolts
and washers. Use bolts that are long enough to
keep the bracket from vibrating during operation.
5. Install two screws (D, included with the heater) into
the top two heater mounting posts until they are
about 1/8 in. (3 mm) from fully installed.
6. Using two people, lift the heater (201) onto the
bracket (205) so the two screw heads (D) slide into
the slots. Have one person hold the heater in place
while the other installs the remaining two screws
(supplied with the heater) through the bracket and
into the bottom mounting posts. Tighten all four
screws.
7. Connect the free end of the heater supply hose
(202) to the swivel (23) at the pump fluid outlet.
Tighten securely.
Fig. 3
1
D
205
23
202
201
206
203
204
2
Refer to text and Mounting Hole Layout on page 27 for
correct positioning.
3
Install top two screws until they are about 1/8 in. (3 mm)
from fully installed.
Connect a 1 to 3 ft (0.3 to 0.9 m) hose here.
1
2
3
22
212
7782C