Graco 25R128, Setup - Operation - Repair

Page: 24 / 92

HMI Display Operation and Identification
24 3A7526B
Input signals status
The input signals display shows the current signal status
from customer inputs.
•
Rate CMD
-
If ‘distributed IO’ is selected as ‘Other CMD
Resource’ on
Advanced Setup Screen 2 , see
page 38, the input voltage signal will be shown
as 0-10.0, where 0 means 0 voltage, 10.0
means 10
V.
- If ‘Gateway’ is selected as ‘Other CMD
Resource’ on
Advanced Setup Screen 2 , see
page 38, the input data sent by Profinet will be
shown as a value from 0 to 1000.
NOTE: The Gateway option is only included in the
Profinet communication mode. Any PR-X system can be
converted to use Profinet communication mode. Order
SD card 18C277 and perform
Software Setup (For
Profinet Communication Mode Only) on page 47.
Output signals status
The output signals display shows the current signal
status from the PR-X control box.
I/O communication
mode
Profinet communication
mode
Error
code Port
code Error
Type
Comment
0 00000 ---- No Error
1 00001 Error
Estop
2 00010 Error Lowest limit has been reached
3 00011 Error
Highest limit has been reached
4 00100 Error Pre-charge time out
5 00101 Error
Pressure relief time out
6 00110 Error Reload time out
7 00111 Error
Servo fault
8 01000 Error Part A Supplier is in low level
9 01001 Error
Part B Supplier is in low level
10 01010 Error Part A pressure exceeds system
limit
11 01011 Error
Part B pressure exceeds system
limit
12 01100 Error Part A/B pressure is not
balanced
13 01101 Error
Servo unit lost power
14 01110 Error Inlet valve A does not turn on in
time
15 01111 Error
Inlet valve B does not turn on in
time
16 10000 Error Dispense valve does not turn on
in time
17 10001 Error
Inlet valve A does not turn off in
time
18 10010 Error Inlet valve B does not turn off in
time
19 10011 Error
Dispense valve does not turn off
in time
20 10100 Error Pressure relief fault
21 10101 Error
Pre-charge fault
22 10110 Error Homing fault
23 10111 Error
Motor torque is over limit
24 11000 Error Motor peak torque is over limit
25 11001
Deviation Illegal setting
26 11010 Deviation Illegal command
27 11011
Deviation Home is lost
28 11100 Deviation Reload is requested (System is
in job) or metering tube pump is
empty (System is not in job)
29 11101 Deviation Purge is requested
30 11110
Deviation Automatic relief after idle
31 11111 Deviation In system relieving