Mounting
English, Revision 06, Date: 14.12.2016
7
2
Mounting
Inside the casing are four drill holes for four M5 screws.
ATTENTION!
Make sure that the antenna is mounted correctly! Check the ori-
entation of the antenna thoroughly!
Figure 2
Mounting the antenna
In order to prevent any adverse effects on the system:
-
The space above the antenna (at least 80 mm) should be kept free of any metal
parts. Make sure that there are comparatively large electrically conductive sys-
tems within this area.
-
To guarantee a perfect operation of the transponder system, it is essential that
there are no interfering signals in the frequency range of 64 ± 4 kHz (e.g. pulse
engines etc.)!
-
Make sure that the transponder track is located centered below the antenna (max.
tolerance ±5 cm). Outside this area the signal strength decreases quickly and
thus readings are unreliable.
NOTE!
The heater has to be used if the antenna is operated at tempera-
tures below 0
o
C! As the heating period lasts about an hour at
-20
o
C it is recommended that the heating is connected to a
standby system.
Reading direction (Transponder)
Direction of travel
Place for mounting (vehicle, ...)
4 screws, type M5
(not included in scope of supply)
