Software
English, Revision 06, Date: 14.12.2016
28
With HyperTerminal the file is transferred as follows:
1.
Choose Send Text file in the menu Transfer. The following window will be
opened:
2.
Switch to disk drive (in our example, the files are located on the hard disk) and
select the respective *.txt file.
3.
Click
. The file will be transferred and (if you have chosen the right file)
the monitor program will be started. The menus will then appear directly in the
HyperTerminal window. At first, you will see the main menu from Figure 14.
5.2.2
How to work with the monitor program
Any change to the interface parameters will be activated after a system reset (switch
the antenna off and on again). Afterwards it may be necessary to use a different file
from the four given *txt. documents for the monitor call!
Once the transfer of the *txt.file (refer to 5.2.1) has been completed, the monitor pro-
gram will start its main menu. If this is not the case, you have either based your settings
on wrong system configuration, you are using a different terminal emulation, you did
not adjust the character delay to 1 ms or you didn‘t wait for a minimum of 10 seconds
after switching teh antenna on.
5.2.2.1
Main Menu
Figure 14
Main menu of the monitor program
S:0055 X:+0007 Code: 00000000 Read: 0:
Frx[/Hz]:66880 Ftx[/Hz]:127960
U[/mV]:24200 I[/mA]: 240 T[Grd.C]:+19 E: 0800 N: 0
(P)assword
(T)ime & Code
(F)requency & Antenna tuning
(S)erial Output
C(A)N-Parameters
P(r)ofibus-Parameters
(L)oad Values to EEProm
(W)rite Transponder
(E)rror - Status
Cs(v) (38,4 KB Code,Sum,Tr,Co,+-,Pos,Read,Cnt<crlf>)
(U)pdate Firmware
Serv(i)ce
Software Version 71895C21.14 / 19.MAR.2009 Serial Number: 9999999
