FS175
Translation of the original operating instruction and spare parts list
- 19-
5007287-00
BA-E
®
Information: Wrong rotation of the blade will result in more wear of the blade!
Information: Clean all fastening devices of the blade (flanges, thread of the blade shaft,
screws and nuts) before mounting the blade!
Important: The operation is to be carried out in wet cutting, in order to prevent the
occurrence of harmful particulate matter and to increase the lifetime of the cutting tool.
3.3.1 Mounting the blade
Blade mounting:
•
Mount the blade to the manufacturer’s odds (Observe the min. flange-Ø; use only original screws or
nuts).
•
Use only blade diameters which are allowed by the manufacturer.
Remove the cutting disc guard and unscrew the outer clamping
flange SW 32, left-hand thread.
All clamping surfaces must be clean and undamaged.
Fit the cutting disc. Pay attention to the correct direction of
rotation!
Observe the direction of rotation arrows on the cutting disc and
the cutting disc guard.
Mount the outer clamping flange again, fit the cutting disc
guard and secure it with the screw.
3.4 Water supply
Danger: Wrong rotation of the blade may result in segments cracking off and can cause
injuries to the operator or other persons!
SW32
Danger: It is not allowed to operate the machine without cutting disc blade guard!
Attention: Tools which are only designed for wet cutting technique, must never be used
without water supply! Always make sure that there is enough water supply!
