GMW IPP 144 - 40 G, User Manual

Page: 54 / 60

Each printer is addressable, which allows the connection of
up to 31 devices to one sender device via a data line at the
RS 485 interface, e.g. to a PLC.
4
53
Review of the
model types
There are two versions of the printer: The basic version
IPP 144-40 G with the Interface I and the enhanced version
IPP 144-40 GE with the Interfaces I and II.
There are three option for the voltage supply: 12V DC (10V...19V
DC) or 24V DC (19V...36V DC) or 110V/230V AC (switch-mode
power supply: 85V...265V AC).Interface
There are four options for the Interface II:
RS 232 C, RS 485, ProfiBus or USB
The connector for the Interface II of RS 232 C, RS 485 and
ProfiBus is a 9 pin D-Sub-socket. It is possible to change this
Interface card in the factory. The interface option USB has a
special USB-B-socket. It is not possible to change this
interface card with the other cards. Special adapter cables
and converters are used in this situation.
Model Supply Voltage Interface I Interface II
IPP 144-40 G
IPP 144-40 GE 232
IPP 144-40 GE 485
IPP 144-40 GE PB
IPP 144-40 GE USB
12V DC 24V DC 110/230V AC
12V DC 24V DC 110/230V AC
12V DC 24V DC 110/230V AC
12V DC 24V DC 110/230V AC
12V DC 24V DC 110/230V AC
Yes None
Yes RS 232 C
Yes RS 485
Yes ProfiBus
Yes USB
Front Rear
1 Status indicator 2 Opening for paper feed
3 Handle 4 Connector for connection
5 Mounting screws cable IPP 144-40;
6 Protective conductor connection (pin connections: Motor
(must be connected to ground)
control, +5V, open, GND)
7 Brightness LED
The paper reroll mechanism is inserted into the DIN size
panel cutout from the front side and is clamped against the
rear of the switchboard using the mounting screws. The
switchboard thickness must not exceed 12 mm.
Make sure that the unit is properly mounted
before connection and power on.
Design
Installation
S P S
77777
Up to 32 printers