GMW IPP 144 - 40 G, User Manual

Page: 51 / 60

Serial 8 kB
Type RS 232 C; RS 422; RS 485
or Current loop
Baudrate 110; 150; 300; 600; 1200;
2400; 4800; 9600; 19200;
38400
Data format 7 bit 1) / 8 bit
Parity bit even, odd, mark, space, no
Safety acc. to EN 61010-1
CAT III > 150 V
≤ 300 V
pollution degree 2
DC 10 V ... 19 V ca. 20 VA
2)
19 V ... 36 V ca. 18 VA
2)
AC 85 V ... 265 V , 45 - 65 Hz,
ca. 15 W
switch-mode power supply
Temperature ranges:
Storage
-20 °C to +60 °C
Operating 0 °C to +45 °C
Climate relative humidity < 80 %
up to 31 °C
Protection type acc. to EN 60529/VDE 0470
Housing IP 50
Terminals IP 00
Insulation group C acc. to VDE 0110
Mech. strength acc. to IEC 1010
EMC
Emission
EN 55011, Class A
EN55022, Class B
Susceptibility EN 61000-4-2 B
EN 61000-4-3 A
EN 61000-4-4 B
1)
With 7 bit no parity, the sender must be set to 2 stop bits.
2) Starting current approx. 3.5 A (10 V ... 19 V) or approx. 1.2 A
(19 V ... 36 V).
This value can be used to rate the external fuse.
Input buffer
Serial
Interface I
Voltage
supply
Ambient
conditions
Standards
50
CE
7
8.4.2. Connection of IPP 144 - 40 G with a DAA
message display to print fault messages
Messages can be sent by all DAA type B and C versions.
(The A version DAA are not capable of outputting data but
only of displaying them since there is only one serial interface
available which is used to receive data).
The connection of the printer is made via the Interface II
(RS 232 C) of the DAA. The printout is normally triggered by
a control device (e.g. a PLC) with a strobe signal (strobe T)
via the terminal strip for control inputs (parallel interface) at
the DAA.
IPP 144-40 G
DAA
2
5 7
2
8
1
5
TxD
CTS
GND
RxD
RTS
GND
Sign.
GND
Strobe T
Interface RS - 232 C:
DAA 144 - 120 B: 9 pin D - SUB 9 pin D - SUB
DAA 288 - 120 B: 25 pin D - SUB
DAA 288 - 240 B, C: 25 pin D - SUB
The required connection cable is available as an accessory.